Universidad Complutense de Madrid
E-Prints Complutense

Sealing and dentin bond strength of adhesive systems in selected areas of perfused teeth



Último año

Escribano, Nuria Isabel y Del-Nero Beneitez, María Olga y Macorra García, José Carlos de la (2001) Sealing and dentin bond strength of adhesive systems in selected areas of perfused teeth. Dental Materials, 17 . pp. 149-155.

[img] PDF


Objectives: (1) Test the sealing capacity and tensile strength of various adhesive systems: Scotch Bond 1 (Single Bond in USA)(SB1) + Z100, Syntac Sprint (SYN) + Tetric Ceram, Prime and Bond 2.1 (PB21) + TPH Spectrum, F2000 (Adhesive 1 Compomer) (F2000) and Optibond Solo (OPT) + Prodigy, to perfused teeth (30 cm distilled H2O), in select areas. (2) Determine the relationship between sealing
ability and size of adhesive area (BA) with tensile strength (TS).
Methods: Segments of human third molars (n=67) sealed with amalgam on their coronal side were connected to a perfusion system (30 cm distilled H2O), to measure the basal permeability. Access cavities were drilled through the amalgam to expose dentin (area range: 8.7±20.8 mm2) and measure the permeability of that area. Cavities were sealed with one of the test materials and permeability measured prior to tensile testing. The percentage of decrease in permeability (PPD) that occurred with the different combinations of materials was also measured.
Results. Tensile strength: there were no statistically signi®cant differences among groups. Permeability: ANOVA showed that there were statistically signi®cant differences in the mean % decrease in permeability (PPD) among groups (p= 0:018): Student-Newman-Keuls test (p=0:05) detected that the mean PPD of F2000 ranked statistically higher than that of SB1. Relationship among variables: a linear
correlation was found defined by the formula TS= 7:47+ 0:008·PPD - 0:23·BA; with a significance of the model p=0.0097.
Significance: None of the materials studied reduced permeability up to 100%. They all produced low tensile bond strengths (maximum mean value of groups: 5.51 MPa (OPT)).

Tipo de documento:Artículo
Palabras clave:Dentin, Adhesive, Sealing, Perfusion, Permeability
Materias:Ciencias Biomédicas > Medicina > Anatomía
Ciencias Biomédicas > Odontología > Materiales dentales
Ciencias Biomédicas > Medicina > Odontología
Ciencias Biomédicas > Medicina > Fisiología
Código ID:5008
Depositado:17 Oct 2005
Última Modificación:29 Nov 2018 11:23

Descargas en el último año

Sólo personal del repositorio: página de control del artículo