Universidad Complutense de Madrid
E-Prints Complutense

Microstructural characterization by electron backscatter diffraction of a hot worked Al-Cu-Mg alloy

Impacto

Downloads

Downloads per month over past year

Cepeda Jimenez, C. M. and Hidalgo Alcalde, Pedro and Carsi, M. and Ruano, O. A. and Carreño, F. (2011) Microstructural characterization by electron backscatter diffraction of a hot worked Al-Cu-Mg alloy. Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 528 (7-ago). pp. 3161-3168. ISSN 0921-5093

[img] PDF
Restringido a Repository staff only hasta 31 December 2020.

1MB

Official URL: http://dx.doi.org/10.1016/j.msea.2010.12.045


URLURL Type
http://www.sciencedirect.comPublisher


Abstract

Hot torsion tests to fracture to simulate thermomechanical processing were carried out on a solution-treated Al-Cu-Mg alloy (Al 2024-T351) at constant temperature. Torsion tests were conducted in the range 278-467 degrees C, and at two strain rates, 2.1 and 4.5 s(-1). Electron backscatter diffraction (EBSD) was employed to characterize the microtexture and microstructure before and after testing. The microstructural evolution during torsion deformation at different temperatures and strain rate conditions determines the mechanical properties at room temperature of the Al 2024 alloy since grain refining, dynamic precipitation and precipitate coalescence occur during the torsion test. These mechanical properties were measured by Vickers microhardness tests. At 408 degrees C and 2.1 s(-1) the optimum combination of solid solution and incipient precipitation gives rise to maximum ductility and large fraction of fine and misoriented grains (f(HAB) = 54%). In contrast, the increase in test temperature to 467 degrees C produces a sharp decrease in ductility, attributed to the high proportion of alloying elements in solid solution. Both the stress-strain flow curves obtained by torsion tests and the final microstructures are a consequence of recovery phenomena and the dynamic nature of the precipitation process taking place during deformation.


Item Type:Article
Additional Information:

© 2010 Elsevier B.V. All rights reserved.
Financial support from CICYT (Project MAT2009-14452) is gratefully acknowledged. C.M. Cepeda-Jimenez thanks the Spanish National Research Council (CSIC) for a I3P contract. We also thank F.F. Gonzalez-Rodriguez for assistance during hot torsion. Finally, an especial mention in memory of P.J. Gonzalez-Aparicio for his help and assistance with electron microscopy during all these years is made.

Uncontrolled Keywords:Aluminum-Alloy, Texture Development, Elevated-Temperatures, Stainless-Steel, Carbon-Steel, Torsion, Deformation, Behavior, Precipitation, Evolution
Subjects:Sciences > Physics > Materials
ID Code:25345
Deposited On:13 May 2014 12:52
Last Modified:13 May 2014 12:52

Origin of downloads

Repository Staff Only: item control page