Universidad Complutense de Madrid
E-Prints Complutense

Guidelines for preparation of higher flux hydrophobic/hydrophilic composite membranes for membrane distillation

Impacto

Downloads

Downloads per month over past year

Qtaishat, M. and Khayet Souhaimi, Mohamed and Matsuura, T. (2009) Guidelines for preparation of higher flux hydrophobic/hydrophilic composite membranes for membrane distillation. Journal of membrane science, 329 (01-feb). pp. 193-200. ISSN 0376-7388

[img] PDF
Restringido a Repository staff only

473kB

Official URL: http://dx.doi.org/10.1016/j.memsci.2008.12.041


URLURL Type
http://www.sciencedirect.com/Publisher


Abstract

For the first time, a mathematical model is presented to validate the hydrophobic/hydrophilic composite membrane concept in membrane distillation (MD). This mathematical model aims at providing the optimal characteristics of both hydrophobic and hydrophilic layers as well as giving the guidelines to prepare highly efficient MD membranes. The model was tested by the experimental data obtained from four laboratory-made and two commercial membranes. A very good agreement between the experimental and theoretical values for the vapour fluxes was obtained. In addition, the effect of morphological characteristics of both hydrophobic top-layer and hydrophilic sub-layer was studied by simulating the permeate flux, when the membranes were used for direct contact membrane distillation (DCMD). Those characteristics include hydrophobic top-layer porosity and hydrophilic sub-layer porosity, thicknesses of the hydrophobic and hydrophilic layers and their thermal conductivity. Throughout the proposed model, a criterion parameter (f(i)) reflecting the hydrophobic top-layer and hydrophilic sub-layer morphology was identified. It was found that the criterion parameter (f(i)) should be lower than unity in order to improve the permeate flux by increasing the hydrophilic sub-layer thickness when the total membrane thickness is constant. All the tested membranes in this study satisfied this requirement. The simulation further indicated that, the calculated DCMD theoretical flux increased enormously with increasing the hydrophilic sub-layer thickness. Moreover, the theoretical flux increased with increasing both the hydrophobic and hydrophilic layers' porosities, but it was more pronounced for the hydrophobic top-layer porosity. It was also found that the permeate flux is highly enhanced by increasing the sub-layer thermal conductivity at infinite heat transfer coefficients, but this effect was less pronounced when the heat transfer coefficients are not infinity.


Item Type:Article
Additional Information:

© 2008 Elsevier B.V. The authors of the present paper gratefully acknowledge the support of the Middle East Desalination Research Centre (MEDRC) through the project 04-AS-006 and the Spanish Ministry of Science and Education (MEC) (Project FIS2006-05323).

Uncontrolled Keywords:Pore-size distribution; Mass-transfer; Porous partition; Contact; Desalination; Transport; Heat; Simulation; MD
Subjects:Sciences > Physics > Thermodynamics
ID Code:26418
Deposited On:27 Aug 2014 09:15
Last Modified:12 Nov 2015 15:57

Origin of downloads

Repository Staff Only: item control page