Universidad Complutense de Madrid
E-Prints Complutense

Mechanical-alloying and lattice distortions in ball-milled CuFe

Impacto

Downloads

Downloads per month over past year

Harris, V. G. and Das,, B.N. and Woicik, J. C. and Crespo del Arco, Patricia and Hemando, A. and Garcia Escorial, A. (1997) Mechanical-alloying and lattice distortions in ball-milled CuFe. Journal de Physique IV, 7 C2 (2). pp. 1151-1152. ISSN 1155-4339

[img]
Preview
PDF
150kB

Official URL: http://dx.doi.org/10.1051/jp4:19972168




Abstract

A least-square fitting analysis of EXAFS data collected from partially-crystallized Fe_80B_20 thin films (t=15 nm), using data collected from pure phase standards of the crystallization products, was found effective in determining the relative atomic fraction of each crystalline phase present. This fitting scheme provides a means for the quantitative treatment of crystallization and precipitation kinetics in thin films and multilayered structures.


Item Type:Article
Additional Information:

©Editions Physique.EDP Sciences.
This research was carried out, in part, at the National Synchrotron Light Source (Brookhaven National Laboratories, Upton, NY), which is sponsored by the U.S. Department of Energy.

Uncontrolled Keywords:Absorption fine-structure; Fcc Fe-Cu; Magnetic-properties
Subjects:Sciences > Physics > Materials
Sciences > Physics > Solid state physics
ID Code:42241
Deposited On:26 Apr 2017 15:05
Last Modified:26 Apr 2017 15:05

Origin of downloads

Repository Staff Only: item control page